Setting up a Dolby Voice Room with Pexip Infinity

Loading

Last Updated on April 15, 2019 by GrahamWalsh

Thanks to the folks over at Dolby, we have been doing some collaboration together which was then showcased at ISE 2019 in Amsterdam. I now have a unit to test it out with fully.

First up, I created a Device Alias on the Pexip Management Node, just a SIP URI, Username and Password

Once that is done, open an browser to your Dolby Voice Phone and the default username is admin and the password is 1739.

Then navigate to IP PBX Settings and populate with your credentials you’ve created in the previous step as per the below screenshot.

To see if it has been successful, you can check the Pexip Management Node under Status > Registered Alias

You can also check the status on the Dolby Voice Room under Status > Dolby Voice Hub > Device > Alarms and Status

You can now call any SIP via Pexip. Note that this is for Audio Only calls. Next post will be about video calls.

There are other configuration guides on the Dolby site here for other voice platforms such as Skype for Business.

All search results
%d